Ipv6 Access-Group - SMC Networks TigerStack II SMC8848M Management Manual

Related Commands
permit, deny (23-11)

ipv6 access-group (23-15)

ipv6 access-group
This command binds a port to an IPv6 ACL. Use the no form to remove
the port.
Syntax
[no] ipv6 access-group acl_name in
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• in – Indicates that this list applies to ingress packets.
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different
ACL, the switch will replace the old binding with the new one.
• IPv6 ACLs can only be applied to ingress packets.
Example
Console(config)#int eth 1/2
Console(config-if)#ipv6 access-group standard david in
Console(config-if)#
Related Commands
show ipv6 access-list (23-14)
IP 6 ACL
V S
23-15