Configuring Interface Connections - SMC Networks TigerStack II SMC8848M Management Manual

P C
ORT ONFIGURATION
CLI – This example shows the connection status for Port 5.
Console#show interfaces status ethernet 1/5
Information of Eth 1/13
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Broadcast storm:
Broadcast storm limit:
Flow control:
LACP:
Port security:
Max MAC count:
Port security action:
Media type:
Current status:
Link status:
Operation speed-duplex: 1000full
Flow control type:
Console#

Configuring Interface Connections

You can use the Port Configuration or Trunk Configuration page to
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed and duplex mode, and
flow control.
Command Attributes
• Name – Allows you to label an interface. (Range: 1-64 characters)
• Admin – Allows you to manually disable an interface. You can disable
an interface due to abnormal behavior (e.g., excessive collisions), and
then reenable it after the problem has been resolved. You may also
disable an interface for security reasons.
• Speed/Duplex – Allows you to manually set the port speed and duplex
mode (i.e., with auto-negotiation disabled).
8-4
1000T
00-30-F1-D4-73-A5
Up
Auto
10half, 10full, 100half, 100full, 1000full
Enabled
500 packets/second
Disabled
Disabled
Disabled
0
None
None
Down
None
24-12