Enabling The Server, Setting Excluded Addresses; Figure 16-2 Dhcp Server General Configuration - SMC Networks TigerStack II SMC8848M Management Manual

Enabling the Server, Setting Excluded Addresses

Enable the DHCP Server and specify the IP addresses that it should not
be assigned to clients.
Command Attributes
• DHCP Server – Enables or disables the DHCP server on this switch.
(Default: Disabled)
• Excluded Addresses – Specifies IP addresses that the DHCP server
should not assign to DHCP clients. You can specify a single address or
an address range.
• New (Excluded Addresses) – New entries for excluded addresses can be
specified as a single address or an address range.
Note: Be sure you exclude the address for this switch and other key
network devices.
Web – Click DHCP, Server, General. Enter a single address or an address
range, and click Add.

Figure 16-2 DHCP Server General Configuration

C
ONFIGURING THE
DHCP S
ERVER
16-5