Sending Simple Mail Transfer Protocol Alerts - SMC Networks TigerStack II SMC8848M Management Manual

B M
ASIC ANAGEMENT
CLI – This example shows the event message stored in RAM.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port
level: 6, module: 5, function: 1, and event no.: 1
Console#

Sending Simple Mail Transfer Protocol Alerts

To alert system administrators of problems, the switch can use SMTP
(Simple Mail Transfer Protocol) to send email messages when triggered by
logging events of a specified level. The messages are sent to specified
SMTP servers on the network and can be retrieved using POP or IMAP
clients.
Command Attributes
• Admin Status – Enables/disables the SMTP function.
(Default: Enabled)
• Email Source Address – Sets the email address used for the "From"
field in alert messages. You may use a symbolic email address that
identifies the switch, or the address of an administrator responsible for
the switch.
• Severity – Sets the syslog severity threshold level (see table on page 4-41)
used to trigger alert messages. All events at this level or higher will be
sent to the configured email recipients. For example, using Level 7 will
report all events from level 7 to level 0. (Default: Level 7)
• SMTP Server List – Specifies a list of up to three recipient SMTP
servers. The switch attempts to connect to the other listed servers if the
first fails. Use the New SMTP Server text field and the Add/Remove
buttons to configure the list.
• Email Destination Address List – Specifies the email recipients of
alert messages. You can specify up to five recipients. Use the New Email
Destination Address text field and the Add/Remove buttons to
configure the list.
4-46
T
ASKS
1 link-up notification."
20-40