Version - SMC Networks TigerStack II SMC8848M Management Manual

IP R C
OUTING OMMANDS

version

This command specifies a RIP version used globally by the router. Use the
no form to restore the default value.
Syntax
version {1 | 2}
no version
• 1 - RIP Version 1
• 2 - RIP Version 2
Command Mode
Router Configuration
Default Setting
RIP Version 1
Command Usage
• When this command is used to specify a global RIP version, any
VLAN interface not previously set by the ip rip receive version or ip
rip send version command will be set to the following values:
- RIP Version 1 configures the unset interfaces to send RIPv1
compatible protocol messages and receive either RIPv1 or RIPv2
protocol messages.
- RIP Version 2 configures the unset interfaces to use RIPv2 for both
sending and receiving protocol messages.
• When the no form of this command is used to restore the default
value, any VLAN interface not previously set by the ip rip receive
version or ip rip send version command will be set to the default
send or receive version.
Example
This example sets the global version for RIP to send and receive version 2
packets.
Console(config-router)#version 2
Console(config-router)#
37-14