Static Multicast Routing Commands; Ip Igmp Snooping Vlan Mrouter; Table 33-4 Static Multicast Routing Commands - SMC Networks 7824M/FSW - annexe 1 Management Manual

Command Usage
The switch must use IGMPv2 or v3 snooping for this command to
take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Related Commands
ip igmp snooping version (33-4)

Static Multicast Routing Commands

This section describes commands used to configure static multicast
routing on the switch.
Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter

ip igmp snooping vlan mrouter

This command statically configures a multicast router port. Use the no
form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• ethernet unit/port
• port-channel channel-id (Range: 1-32)

Table 33-4 Static Multicast Routing Commands

Function
Adds a multicast router port
Shows multicast router ports
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
S M
TATIC ULTICAST
R C
OUTING OMMANDS
Mode Page
GC
PE
33-13
33-13
33-14