Telnet Server Commands; Ip Telnet Server; Table 22-9 Telnet Server Commands - SMC Networks TigerStack II SMC8848M Management Manual

U A
SER UTHENTICATION

Telnet Server Commands

This section describes commands used to configure Telnet management
access to the switch.
Command

ip telnet server

ip telnet server
This command allows this device to be monitored or configured from
Telnet. It also specifies the TCP port number used by the Telnet interface.
Use the no form without the "port" keyword to disable this function. Use
the no from with the "port" keyword to use the default port.
Syntax
ip telnet server [port port-number]
no telnet server [port]
• port - The TCP port used by the Telnet interface.
• port-number - The TCP port number to be used by the browser
interface. (Range: 1-65535)
Default Setting
• Server: Enabled
• Server Port: 23
Command Mode
Global Configuration
Example
Console(config)#ip telnet server
Console(config)#ip telnet port 123
Console(config)#
22-20
C
OMMANDS

Table 22-9 Telnet Server Commands

Function
Allows the switch to be monitored or
configured from Telnet; also specifies the
port to be used by the Telnet interface
Mode Page
GC 22-16