SMC Networks TigerStack II SMC8848M Management Manual page 687

The commands described in this section are used to configure
Differentiated Services (DiffServ) classification criteria and service
policies. You can classify traffic based on access lists, IP Precedence or
DSCP values, or VLANs. Using access lists allows you select traffic based
on Layer 2, Layer 3, or Layer 4 information contained in each packet.
Table 32-1 Quality of Service Commands
Command
class-map
match
policy-map
class
set
police
service-policy
show class-map
Q
UALITY OF
Function
Creates a class map for a type of traffic
Defines the criteria used to classify traffic
Creates a policy map for multiple interfaces GC
Defines a traffic classification for the policy
to act on
Classifies IP traffic by setting a CoS, DSCP,
or IP-precedence value in a packet
Defines an enforcer for classified traffic
Applies a policy map defined by the
policy-map command to the input of a
particular interface
Displays the QoS class maps which define
matching criteria used for classifying traffic
C
HAPTER
S
ERVICE
C
OMMANDS
32
Mode Page
GC 32-3
CM 32-4
32-5
PM 32-6
PM-C 32-8
PM-C 32-9
IC 32-10
PE 32-11
32-1