Adding Static Members To Vlans (Vlan Index) - SMC Networks TigerStack II SMC8848M Management Manual

VLAN C
ONFIGURATION
CLI – This example creates a new VLAN.
Console(config)#vlan database
Console(config-vlan)#vlan 2 name R&D media ethernet state active
Console(config-vlan)#end
Console#show vlan
VLAN ID:
Type:
Name:
Status:
Ports/Port Channels:
.
.
.
VLAN ID:
Type:
Name:
Status:
Ports/Port Channels:
Console#

Adding Static Members to VLANs (VLAN Index)

Use the VLAN Static Table to configure port members for the selected
VLAN index. Assign ports as tagged if they are connected to 802.1Q
VLAN compliant devices, or untagged they are not connected to any
VLAN-aware devices. Or configure a port as forbidden to prevent the
switch from automatically adding it to a VLAN via the GVRP protocol.
Notes: 1. You can also use the VLAN Static Membership by Port page
2. VLAN 1 is the default untagged VLAN containing all ports on
Command Attributes
• VLAN – ID of configured VLAN (1-4093).
• Name – Name of the VLAN (1 to 32 characters).
11-10
1
Static
DefaultVlan
Active
Eth1/ 1(S) Eth1/ 2(S) Eth1/ 3(S) Eth1/ 4(S) Eth1/ 5(S)
Eth1/ 6(S) Eth1/ 7(S) Eth1/ 8(S) Eth1/ 9(S) Eth1/10(S)
Eth1/11(S) Eth1/12(S) Eth1/13(S) Eth1/14(S) Eth1/15(S)
Eth1/16(S) Eth1/17(S) Eth1/18(S) Eth1/19(S) Eth1/20(S)
Eth1/21(S) Eth1/22(S) Eth1/23(S) Eth1/24(S)
2
Static
R&D
Active
to configure VLAN groups based on the port index (page 13).
However, note that this configuration page can only add ports
to a VLAN as tagged members.
the switch, and can only be modified by first reassigning the
default port VLAN ID as described under "Configuring
VLAN Behavior for Interfaces" on page 11-14.
30-7
30-8
30-16