Basic Display - Omron RX User Manual

Basic Display

•Displays basic parameters. (Factory default)
•Below are the parameters displayed when this function is enabled.
No. Data
1 d001 to d104 Monitor display
2 F001 Output frequency setting/monitor
3 F002 Acceleration time 1
4 F003 Deceleration time 1
Operator rotation direction
5 F004
selection
6 A001 Frequency reference selection
7 A002 RUN command selection
8 A003 Base frequency
9 A004 Maximum frequency
10 A005 O/OI selection
11 A020 Multi-step speed reference 0
12 A021 Multi-step speed reference 1
13 A022 Multi-step speed reference 2
14 A023 Multi-step speed reference 3
15 A044 V/f characteristics selection
Related functions
Initial Screen Selection (Initial Screen at Power-ON)
You can select the Digital Operator screen to be displayed at power-on among the following items.
(By factory default, "01" (d001) is selected.)
Parameter No. Function name
b038 Initial screen selection
Note: With "00" (screen on which the Enter key was last pressed) selected, if the last screen is other than d*** or
F***, the entrance (*---) of each group is displayed.
(Example) When the power is turned off and then on after a change in the A020 setting, "A---" is displayed.
Function name No.
16
17
18
19
20
21
22
23
24
25
26
27
28
29
00: Screen when the Enter key was pressed
last
01: d001 (Output frequency monitor)
02: d002 (Output current monitor)
03: d003 (Rotation direction monitor)
04: d007 (Output frequency monitor [after
conversion])
05: F001 (Output frequency setting/monitor)
4-2 Function Mode
Data Function name
A045 Output voltage gain
A085 RUN mode selection
b001 Retry selection
Allowable momentary power
b002
interruption time
b008 Trip retry selection
b011 Trip retry wait time
b037 Display selection
b083 Carrier frequency
b084 Initialization selection
Overvoltage protection function
b130
selection during deceleration
Overvoltage protection level
b131
during deceleration
Multi-function output terminal 11
C021
selection
Multi-function output terminal 12
C022
selection
C036 Relay output (AL2, AL1) contact
U001 to U012
Data Default setting Unit
⎯
01
4-56
4