Level 2 Mode - Omron E5AK User Manual

CHAPTER 5 PARAMETERS

Level 2 Mode

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" to "2".
• This mode contains the auxiliary parameters for adjusting control. These parame-
ters include parameters for limiting the manipulated variable and set point,
parameters for switching between remote and local operation, and parameters for
setting the LBA (Loop Break Alarm), alarm hysteresis, and input digital filter
values.
• To select this mode when in the levels 0 and 1, setup, expansion, option and cal-
ibration modes, press the
the menu display. If you select [
key for 1 second minimum, the controller enters the level 2 mode.
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--18
key for 1 second minimum. The display changes to
or keys.
Symbol
Remote/Local
SP mode
SP ramp time unit
SP ramp set value
LBA detection time
MV at stop
MV at PV error
MV upper limit
MV lower limit
MV change rate limit
Input digital filter
Open/close hysteresis
Alarm 1 hysteresis
Alarm 2 hysteresis
Alarm 3 hysteresis
Input shift upper limit (temperature)
Input shift lower limit (temperature)
] using the
key. To change parameter set-
Parameter Name
key then press the
Page
5-19
5-19
5-20
5-20
5-21
5-21
5-21
5-22
5-22
5-22
5-23
5-23
5-24
5-24
5-24
5-24
5-24