Omron E5AK User Manual page 43

Setting Example
1 second min.
1 second min.
1 second min.
About the Decimal
Point of the Alarm
Value
When a set point for a temperature exceeds 10%, alarm1 will be out-
put.
In this example, let's set the parameters as follows:
"alarm type 1"
"alarm value 1"
"alarm hysteresis"
"close in alarm/open in alarm"= "
Meanings of parameters, "alarm hysteresis" and "open in alarm/close
in alarm" are the same settings at the shipment, so settings for opera-
tions are omitted.
(1) Select the menu display, and select [
or keys. For details on selecting the menu display, see page
1-8.
(2) Press the key to enter the setup mode. The top parameter in
the setup mode [
the parameter setting is "17: 4 to 20 mA".
(3) Press the key until [
played. The parameter default is "2: deviation upper limit".
(4) Press the key to return to "1: deviation upper-and lower-lim-
it".
(5) Select the menu key, and select [
or keys. For details on selecting the menu display, see page
1-8.
(6) Press the key to enter the level 1 mode. The top parameter in
the level 1 mode [
(7) Press the key until [
played.
(8) In this example, the parameter setting is "0.0" so press the
until "10.0" is displayed.
The decimal point of the alarm value conforms to the setting of the "decimal
point" parameter (setup mode). In this example, the "decimal point" parameter
is set to "1". (During temperature input, the decimal point of the alarm value
conforms to the set sensor.)
3.4 Setting Alarm Type
= "1: (deviation upper-and lower-limit)"
= "10"
= "0.20"
: close in alarm"
] (setup mode) using the
] "input type" is displayed. In this example,
] ("alarm type 1" parameter) is dis-
] (level 1 mode) using the
] "AT execute/cancel" is displayed.
] ("alarm value 1" parameter) is dis-
key
3--11