Calibration Mode; Selecting Modes; Menu Display; Output - Omron E5AK User Manual

CHAPTER 1 INTRODUCTION
F Calibration mode
J Selecting modes
F Menu display
F Level 0 to 2
modes
1--8
set the communications conditions, transfer output and event input
parameters to match the type of option unit set in the controller. Heater
burnout latch function, position-proportional travel time and remote
SP scaling parameters are also located in this mode.
This mode is provided so that the user can calibrate inputs and transfer

output.

When calibrating input, the selected input type is calibrated. Whereas,
transfer output can be calibrated only when the communications unit
(E53-AKF) is set in the controller.
The following diagram shows the order in which modes are selected.
1 second min.
1 second min.
1 second min.
1 second min.
1 second min.
Expansion mode
1 second min.
1 second min.

Calibration mode

• To select the menu display in any of the above modes (excluding the
protect mode and manual mode), press the
mum. If you select the desired mode using the
press the key, the top parameter in the specified mode is dis-
played.
• When you have selected the menu display, the previous mode is
selected. For example, if you selected the menu display while in the
level 0 mode, the No.2 display changes to [
• Protected modes cannot be selected. Also, the menu display does not
appear when modes are protected up to the level 1 mode.
• If you select [ ] [
level 1 and level 2 modes, respectively, are selected.
• These modes are selected with control still continuing.
Power ON
A/M
1 second min.
Level 0 mode
Level 1 mode
Level 2 mode
A/M
1 second min.
Setup mode
Option mode
] or [ ] in the menu display, the level 0,
Manual mode
A/M
1 second min.
+ +
A/M
1 second min.
Protect mode
+
A/M
1 second min.
key for 1 second mini-
or keys and
] as shown on the left.