Direct/Reverse Operation; Control Period - Omron E5AK User Manual

CHAPTER 3 BASIC OPERATION
Setting Example
1 second min.
1 second min.
1 second min.
3--8
In this example, let's set the parameters as follows:
"control output 1 assignment" = "control output (heat)"
"control output 2 assignment" = "alarm output 1"

"direct/reverse operation"

"control period"

"run/stop"
All of the above settings in this example are factory settings. So, in this
example, we are only going to check the parameter settings.
(1) Select the menu display, and select [
or keys. For details on selecting the menu display, see page
1-8.
(2) Press the key to enter the setup mode. The top parameter in
the setup mode [
the parameter setting is "17: 4 to 20 mA."
(3) Press the key until [
parameter) is displayed. The parameter default is [
(4) As the setting in this example is to be left as it is, press the
The display changes to [
parameter). The parameter default is [
(5) As the setting in this example is to be left as it is, press the
until [ ] ("direct/reverse operation" parameter) is displayed.
The parameter default is [
(6) As the setting in this example is to be left as it is, press the
keys to select [
the menu display, see page 1-8.
(7) Press the key to enter the level 1 mode. The top parameter in
the level 1 mode [
(8) Press the key until [
played. The parameter default is "20". As the setting in this exam-
ple is to be left as it is, quit key operation.
= "reverse operation"
= "20 secs"
= "run"
] (setup mode) using the
] "input type" is displayed. In this example,
] ("control output 1 assignment"
] ("control output 2 assignment"
].
] (level 1 mode). For details on selecting
] "AT execute/cancel" is displayed.
] ("control period" parameter) is dis-
].
key.
].
key
or