Level 1 Mode - Omron E5AK User Manual

CHAPTER 5 PARAMETERS

Level 1 Mode

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" to "3".
• This mode contains the main parameters for adjusting control. These parameters
include parameters for executing AT (auto-tuning), setting the alarm values, set-
ting the control period, and setting PID parameters.
• To select this mode when in the levels 0 and 2, setup, expansion, option and cal-
ibration modes, press the
the menu display. If you select [
mum, the controller enters the level 1 mode.
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--10
key for 1 second minimum. The display changes to
or keys.
Symbol
AT Execute/Cancel
Set point 0
Set point 1
Set point 2
Set point 3
Alarm value 1
Alarm value 2
Alarm value 3
Proportional band
Integral time
Derivative time
Cooling coefficient
Dead band
Position-proportional dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
Control period (heat)
Control period (cool)
Heater current monitor
Heater burnout
] then press the
key. To change parameter set-
Parameter Name
key for 1 second mini-
Page
5-11
5-11
5-11
5-11
5-11
5-12
5-12
5-12
5-12
5-12
5-12
5-13
5-14
5-14
5-15
5-15
5-15
5-16
5-16
5-17
5-17