Omron E5AK User Manual page 93

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" and "1".
• This mode contains the parameters for setting the basic specifications of the
E5AK controller. These parameters include parameters for specifying the input
type, scaling, output assignments, and direct/reverse operation.
• To select this mode when in the levels 0 to 2, expansion, option and calibration
modes, press the
display. If you select [
second minimum, the controller enters the setup mode.
• To select parameters in this mode, press the
tings, use the or
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
key for 1 second minimum. The display changes to the menu
] using the
keys.
Parameter Name
Input type
Scaling upper limit
Scaling lower limit
Decimal point
_C/_F selection
Parameter initialize
Control output 1 assignment
Control output 2 assignment
Auxiliary output 1 assignment
Auxiliary output 2 assignment
Alarm 1 type
Alarm 1 open in alarm
Alarm 2 type
Alarm 2 open in alarm
Alarm 3 type
Alarm 3 open in alarm
Direct/Reverse operation
Setup Mode
key then press the
key. To change parameter set-
Page
5-26
5-27
5-27
5-27
5-28
5-27
5-28
5-28
5-29
5-29
5-30
5-31
5-30
5-31
5-30
5-31
5-31
key for 1
5--25