Multi-Sp - Omron E5AK User Manual

F Assignment
example
J Multi-SP
• In this example, set four event inputs are used, the multi-SP function
to "2", and event input 3 to "Run/Stop" and event input 4 to "Auto/
Manual". Set as follows:
(1) Set "multi-SP function" parameter to "2"
(2) Set "event input assignment 3" parameter to "
(3) Set "event input assignment 4" parameter to "
Event input
• Set points 0 to 3 are set as the set point according to event input.
However, note that these parameters can not be set when the mul-
ti-SP function is not selected. The following table shows the relation-
ship between event inputs and set points 0 to 3.
Multi-SP Function
Event Input
Set Point 0
Set Point 1
Set Point 2
Set Point 3
* When using 2 event inputs, the multi-SP function is assigned to
event inputs 3 and 4.
• When you have changed the set point in the PV/SP display, the set
point of the currently selected is also simultaneously changed.
• When you have switched between set point 0 to 3, the SP ramp function
works if the SP ramp function is enabled. The following example shows
how the set point changes when you switch from set point 0 to set point
1.
SP
set point 1
set point 0
Event input
OFF
4.3 How to Use Event Input
1 2 3 4

Multi-SP

Auto/Manual
Run/Stop
1
1 (3)* 1 (3)*
OFF OFF
ON ON
- OFF
- ON
SP
ramp
Time
ON
"
"
2
2 (4)*
OFF
OFF
ON
ON
4--9