Program Example; How To Use Programs; Conditions When Running A Program - Omron E5AK User Manual

CHAPTER 6 USING THE COMMUNICATIONS FUNCTION

6.6 Program Example

J How to use programs
The program described below is for obtaining corresponding response frame data
when some of the command frame data is input.
The input format is as follows. The FCS and terminator are automatically gener-
ated, and need not be input.
@
The output format is as follows. The content of the response frame is displayed as it
is.
@
F Procedure
(1) Read the program.
(2) Enter "RUN".
(3) When "send data:" is displayed, enter the command data (from @ to the com-
(4) The content of the response frame is displayed following "receive data:".
F Conditions when running a program
• Set the communications condition as follows:
• Make sure that the communications cable is properly connected.
6--14
2B 1B 2B
Unit Command
code
No.
Command type
Input data
2B 1B 2B 2B
Unit End
Command
code
No. code
Command type
mand string).
Baud rate : 9600 bps
Bit length : 7 bits
Parity : Even
Stop bit : 2
4B 2B
FCS
Data
*
Automatically
generated
4B
FCS
Data
2B
CR
2B 2B
* CR