Omron E5AK User Manual page 160

APPENDIX
Mode Parameter Name
Multi-SP function
Event input assignment 1
Event input assignment 2
Event input assignment 3
Event input assignment 4
Communication stop bit
Communication data length
Communication parity
Communication baud rate
Communication unit No.
Transfer output type
Option Option
Transfer output upper limit
Transfer output lower limit
HBA latch
Motor calibration
Travel time
PV dead band
Remote SP enable
Remote SP upper limit
Remote SP lower limit
SP tracking
*5 Set the transfer output type parameter according to the following table.
Transfer Output Type
SP :Set point
SP-M :Set point during SP ramp
PV :Process value
O :Manipulated variable
(heat)
C-O :Manipulated variable
(cool)
V-M :Value opening
Default : SP
D
The output ranges of the SP setting, set point or process value when temperature input is selected are the ranges sup-
D
ported by the selected sensor.
When the heating side manipulated variable or cooling side manipulated variable is selected, the transfer output lower limit
D
in a heating and cooling control becomes "0.0".
A--10
Setting Range
0 to 2
NON/STOP/RMT/MAN/RSP
NON/STOP/RMT/MAN/RSP
NON/STOP/RMT/MAN/RSP
NON/STOP/RMT/MAN/RSP
1/2
7/8
None/Even/Odd
1.2/2.4/4.8/9.6/19.2
0 to 99
SP/SP-M/PV/O/C-O/V-M
*5
*5
ON/OFF
ON/OFF
1 to 999
0 to 9999
ON/OFF
SP setting lower limit to SP setting
upper limit
SP setting lower limit to SP setting
upper limit
ON/OFF
Transfer Output Lower Limit to Transfer Output Upper Limit
Set point lower limit to Set point upper limit
Set point lower limit to Set point upper limit
Scaling lower limit to scaling upper limit
-5.0 to 105.0%
0.0 to 105.0%
-10.0 to 110.0%
Unit Default Remarks
None 0
None NON
None NON
None STOP
None MAN
bits 2
bits 7
None EVEN
kbps 9.6
None 0
None SP
*5 *5
*5 *5
None OFF
None OFF
Sec 1
EU 0
None OFF
EU 1300
EU -200
None OFF
Setting