Omron E5AK User Manual page 122

CHAPTER 6 USING THE COMMUNICATIONS FUNCTION
Parameter No.
44 SP ramp time unit
45 SP ramp set value
46 LBA detection time
47 MV at stop
48 MV at PV error
50 MV upper limit
49 MV lower limit
51 MV change rate limit
56 Input digital filter
88 Open/close hysteresis
25 Alarm 1 hysteresis
26 Alarm 2 hysteresis
52 Alarm 3 hysteresis
53 Input shift upper limit
54 Input shift lower limit
57 Input type
59 Scaling upper limit
58 Scaling lower limit
60 Decimal point
30 _C/_F selection
61 Control output 1 assignment
62 Control output 2 assignment
63 Auxiliary output 1 assignment
64 Auxiliary output 2 assignment
65 Alarm 1 type
66 Alarm 1 open in alarm
67 Alarm 2 type
68 Alarm 2 open in alarm
69 Alarm 3 type
70 Alarm 3 open in alarm
71 Direct/Reverse operation
*1 During heating and cooling control, the range becomes -105 to 105.0. During position-proportional control, you can select
between
*1 0: Hold/1: Open/2: Close. (Default is 0: Hold.)
*2 During heating and cooling control, the range becomes 0.0 to 105.0.
*3 During heating and cooling control, the range becomes -105.0 to 0.0
*4 See page 5-26.
*5 0: Control output (heat), 1: Control output (cool), 2: to 4: Alarms 1 to 3, 5: HBA, 6: LBA, 7 to 9: Errors 1 to 3
*6 See page 5-30.
6--8
Parameter Data Setting Range
0: Minutes, 1: Hours
0 to 9999
0 to 9999
-5.0 to 105.0
-5.0 to 105.0
MV lower limit +0.1 to 105.0
-5.0 to MV upper limit -0.1
0.0 to 100.0
0 to 9999
0.1 to 20.0
0.01 to 99.99
0.01 to 99.99
0.01 to 99.99
-199.9 to 999.9
-199.9 to 999.9
0 to 21
Scaling lower limit +1 to 9999
-1999 to scaling upper limit -1
0 to 3
0 : _C, 1 : _F
0 to 6
0 to 6
2 to 9
2 to 9
1 to 11
0: closed in alarm, 1: open in alarm
1 to 11
0: closed in alarm, 1: open in alarm
1 to 11
0: closed in alarm, 1: open in alarm
0: Reverse operation, 1: Direct operation
Mode
*1
*1
*2
*3
Level 2
*4
*5
*5
*5
Setup Setup
*5
*6
*6
*6