Ricoh Pro C7500 Original Instructions Manual page 99

• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
2. Print 10 or more A3 sheets. Has the problem been resolved?
Yes Go to the next step.
No Start over from Step 1.
3. Is the toner fusibility within the permissible range?
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact
glass.
Yes Finished!
No Change the print speed to "Low". Go to "(b) Changing the fusing temperature (If
[Print Speed] is set to [Low])".
(b) Changing the fusing temperature (If [Print Speed] is set to [Low])
1. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 20°C.
2. Set the value in the following corresponding settings to 0°C.
Productivity Priority
• 1232-02: Fusing Temperature: BW/FC/FCS: Correct Temp: Initial Feed
• 1232-10: Fusing Temperature: FCS: Correct Temp: Initial Feed: Clear/Special
• 1232-11: Fusing Temperature: FCS: Correct Temp: Initial Feed: White
• 1232-12: Fusing Temperature: FCS: Correct Temp: Initial Feed: Metallic
• 1232-30: Fusing Temperature: S: Correct Temp: Initial Feed: Clear/Special
• 1232-31: Fusing Temperature: S: Correct Temp: Initial Feed: White
• 1232-32: Fusing Temperature: S: Correct Temp: Initial Feed: Metallic
High Quality
• 1232-47: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Initial Feed
• 1232-55: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/
Special
• 1232-56: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: White
Uneven Density
97