Ricoh Pro C7500 Original Instructions Manual page 43

Solution:
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then check the present value in the following corresponding settings.
• 1212-01: Image Transfer Output: BW: Black
• 1212-02: Image Transfer Output: FC/FCS: Black
• 1212-03: Image Transfer Output: FC/FCS: Cyan
• 1212-04: Image Transfer Output: FC/FCS: Magenta
• 1212-05: Image Transfer Output: FC/FCS: Yellow
• 1212-06: Image Transfer Output: FC/FCS: Clear/Special
• 1212-07: Image Transfer Output: FC/FCS: White
• 1212-08: Image Transfer Output: FC/FCS: Metallic
If the value is set to below "10"
If the value is set to "10" (upper limit)
3. Does any of the following problems occur?
• Drum imprint
• A black image is faint.
• Edge of an image is faint.
Yes Proceed to Step 7.
No Proceed to Step 8.
4. Increase the value for intermediate (image) transfer output by one step.
5. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Start over from Step 2.
6. Does any of the following problems occur?
• Drum imprint
• A black image is faint.
• Edge of an image is faint.
Yes Go to the next step.
Go to the next step.
Proceed to Step 4.
Dirtied Printouts
41