Ricoh Pro C7500 Original Instructions Manual page 196

6. Image Quality Problem: Spots
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact
glass.
Yes
No
(b) Changing the fusing temperature (If [Print Speed] is set to [Low])
1. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 20°C.
2. Change the temperature adjustment for the initial paper feeding to "0°C".
Productivity Priority
• 1232-02: Fusing Temperature: BW/FC/FCS: Correct Temp: Initial Feed
• 1232-10: Fusing Temperature: FCS: Correct Temp: Initial Feed: Clear/Special
• 1232-11: Fusing Temperature: FCS: Correct Temp: Initial Feed: White
• 1232-12: Fusing Temperature: FCS: Correct Temp: Initial Feed: Metallic
• 1232-30: Fusing Temperature: S: Correct Temp: Initial Feed: Clear/Special
• 1232-31: Fusing Temperature: S: Correct Temp: Initial Feed: White
• 1232-32: Fusing Temperature: S: Correct Temp: Initial Feed: Metallic
High Quality
• 1232-47: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Initial Feed
• 1232-55: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/
Special
• 1232-56: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-57: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
• 1232-75: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/Special
• 1232-76: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-77: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
3. Select [Correct Temp: Initial Feed], and then set the value in the following corresponding
settings to 5°C.
Productivity Priority
• 1232-03: Fusing Temperature: BW/FC/FCS: Correct Temp: Pre-Feed
• 1232-14: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Clear/Special
• 1232-15: Fusing Temperature: FCS: Correct Temp: Pre-Feed: White
• 1232-16: Fusing Temperature: FCS: Correct Temp: Pre-Feed: Metallic
194
Finished!
Change the print speed to "Low". Go to "(b) Changing the fusing temperature (If
[Print Speed] is set to [Low])".