4. Image Quality Problem: Full Page
2.
In [Detailed settings] for custom paper, Select 1212: [Image Transfer Output], and then
check if the value for the intermediate (image) transfer output for the mode you use is set
to "+10" (upper limit).
• 1212-01: Image Transfer Output: BW: Black
• 1212-02: Image Transfer Output: FC/FCS: Black
• 1212-03: Image Transfer Output: FC/FCS: Cyan
• 1212-04: Image Transfer Output: FC/FCS: Magenta
• 1212-05: Image Transfer Output: FC/FCS: Yellow
• 1212-06: Image Transfer Output: FC/FCS: Clear/Special
• 1212-07: Image Transfer Output: FC/FCS: White
• 1212-08: Image Transfer Output: FC/FCS: Metallic
• 1212-10: Image Transfer Output: S: Clear/Special
• 1212-11: Image Transfer Output: S: White
• 1212-12: Image Transfer Output: S: Metallic
Yes
No
3.
Increase the value by one step.
4.
Print the image. Has the problem been resolved?
Yes
No
(b) Adjusting the printing speed
1.
In [Detailed settings] for the custom paper you are using, select 1231: [Print Speed], and
then set the value in the following corresponding settings to [Low].
Productivity Priority
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
44
If already set to the upper limit, there is no other solution.
Go to the next step.
Finished!
Start over from Step 3.