Ricoh Pro C7500 Original Instructions Manual page 65

4. Check if the density has improved.
Yes Go back to Step 2 and increase the image transfer output by one more step.
Print again to check the adjustment result.
• Depending on the paper, increasing the image transfer output by one step
may not be sufficient to achieve the effect. While checking the result, increase
the value one step at a time up to "+5".
• Decreasing the value too much may cause faint printing and negative
ghosting.
No Go to the next step.
5. Restore the value in 1212: [Image Transfer Output] to its previous setting.
6. Select 1214: [Paper Transfer Output], decrease the value in the following corresponding
settings by 1.
• 1214-01: Paper Transfer Output: BW: Side 1
• 1214-02: Paper Transfer Output: BW: Side 2
• 1214-05: Paper Transfer Output: FC/FCS: Side 1
• 1214-06: Paper Transfer Output: FC/FCS: Side 2
• 1214-09: Paper Transfer Output: FCS: Side 1
• 1214-10: Paper Transfer Output: FCS: Side 2
7. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
8. Check if the density has improved.
Yes Go back to Step 6 and decrease the paper transfer output by one more step.
Print again to check the adjustment result.
• Depending on the paper, decreasing the paper transfer output by one step
may not be sufficient to achieve the effect. While checking the result, decrease
the value one step at a time up to "-5".
• Decreasing the value too much may cause faint printing.
No No further improvement is likely.
Uneven Density
63