4.
Check to see if the fusibility is within the acceptable range.
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact
glass.
Yes
Go to the next step.
No
Proceed to "Troubleshooting Flow B"
5.
Check to see if creases and worms marks have disappeared.
Yes
Finished!
No
Start over from Step 2.
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
(b) Troubleshooting Flow B
1.
In [Detailed settings] for custom paper, select 1241-01: [Fusing Nip Width Adjustment:
Other than Envelope], and then check the value of the fusing nip width.
"Nip Width 3" or "Nip Width 4"
Other than "Nip Width 3" or "Nip Width 4"
2.
Select 1232: [Fusing Temperature], and then increase value for the fusing heat roller
temperature by 10°C from the default value.
3.
Go back to 1241-01: [Fusing Nip Width Adjustment: Other than Envelope], and then
change it to "Nip Width 2".
4.
Print the image. (20 or more sheets of A4 paper)
5.
Check to see if the fusibility is within the acceptable range.
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
Streaks, Scratches, Disturbed Image, Crease
Go to the next step.
Proceed to Step 7.
233