Ricoh Pro C7500 Original Instructions Manual page 131

• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• Doing this may cause color tones to change.
(b) Adjusting the paper transfer speed
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for the custom paper you are using, select 1341: [Motor Speed],
decrease the value in 02: [Paper Transfer Belt] by 0.1%.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 2.
If the problem persists even after decreasing the value to "-0.5", there is no other
solution.
• Errors may occur depending on the degree of adjustment and conditions. In such a case, contact
your service representative.
• Decreasing the paper transfer roller speed may cause the image to expand or contract in the
subscanning direction. Such a problem may be resolved by increasing the value for [Image
Magnification] in [Manual Adjustment] in [Adjust image position] on the [Media] hub.
(c) Adjusting the environment
Perform the following solution within the permissible range:
• Lower the temperature and humidity.
• Change to non-slippery paper.
• In [Detailed settings] for the custom paper you are using, select 1237: [Print Speed (Sheet
Interval Adj)], decrease the value in the following corresponding settings.
• Reducing throughput can reduce the occurrence of patchy images when printing with special toner
(clear).
Unprinted
129