Ricoh Pro C7500 Original Instructions Manual page 271

7. To feed paper from Extension output banner sheet tray, attach the side fences and end
fence for extra-long paper.
For details, see page 279 "Attaching the Side Fences, Auxiliary Side Fence, and End Fence (for
Long Paper)".
Otherwise, go to the next step.
8. Check if the double feeding is resolved.
Yes Finished!
No Go to the next step.
9. In [Detailed settings] for custom paper, select 1301: [2-Tray LCIT: Paper Feed Mode] and
set [Paper Feed Mode:Fan Level] to [Prevent Double Feed (Weaker Blow)].
• If set to [Prevent Double Feed (Weaker Blow)], paper misfeeds may be prone to occur with
paper with a width of 182 mm to 225 mm (7.2 inches to 8.9 inches). If this happens, attach
the small tab end fence. For details, see page 279 "Attaching the Small Tab End Fence to the
Wide Large Capacity Tray".
10. Check if the double feeding is resolved.
Yes Finished!
No Go to the next step.
11. In [Detailed settings] for custom paper, select 1301: [2-Tray LCIT: Paper Feed Mode] and
set [Paper Feed Mode:Fan Level] to [Prevent Double Feed (Weakest Blow)].
• If set to [Prevent Double Feed (Weakest Blow)], paper misfeeds may be prone to occur with
paper with a width of 182 mm to 225 mm (7.2 inches to 8.9 inches). For details, see
page 279 "Attaching the Small Tab End Fence to the Wide Large Capacity Tray".
12. Check if the double feeding is resolved.
Yes Finished!
No Go to the next step.
13. In [Detailed settings] for custom paper, select 1303-02: [Extend Fan Operating Time],
and then change it from "Off" to "On".
14. Check if the double feeding is resolved.
Yes Finished!
Vacuum Feed LCIT RT5150
269