Image Deformation, Scratches, Streaks, Paper Creases Or Bent Corners - Ricoh Pro C7500 Original Instructions Manual

Image Deformation, Scratches, Streaks, Paper Creases or Bent Corners

Cause:
• The paper exit roller is stained.
• The line speed of the exit motor or the paper feed speed at the switchback entrance/exit is too fast
or too slow.
• The paper feed speed is too fast or too slow for the decurler unit operation.
• The decurling direction or strength of the decurler unit is not specified correctly.
Solution: (Adjust the line speed of the paper exit motor and the paper feed speed at
the switchback entrance/exit)
If the problem persists even after the paper exit roller is cleaned, adjust the line speed of the paper exit
motor and the paper feed speed at the switchback entrance/exit.
(a) Scratches or Streaks on the Back of the Pape
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, select 1341: [Motor Speed], and then decrease
the value for the applicable setting by 0.1%.
If this problem occurs with single-sided printing
If this problem occurs with duplex printing
If this problem occurs only with turned-over
paper delivery
3. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 2.
If the problem persists even after the values are decreased by up to 1.0% in total,
there is a possibility of another cause, so restore the previous settings and see other
troubleshooting methods.
(b) Scratches or Streaks on the Front of the Paper / Paper Creases or Bent Corners
1. If the paper is not registered as custom paper, register the brand of the paper.
Streaks, Scratches, Disturbed Image, Crease
1341-09: Motor Speed: Speed Adjustment:
Paper Output Roller
1341-10: Motor Speed: Speed Adjustment:
Switchback: Entrance Roller
1341-11: Motor Speed: Speed Adjustment:
Switchback: Exit Roller
227