Ricoh Pro C7500 Original Instructions Manual page 300

11. Post-Processing Option Troubleshooting
[A]: End fence
3. The flap is thinner than other parts of the envelope, so the height of the tray is prone to be higher
than the paper exit roller as more envelopes are stacked. The angle of paper delivery becomes
steep, resulting in increased resistance, and failure to deliver the envelope.
[A]: End fence
Solution:
Using the Z-fold support tray changes the position of the leading edge of the envelope to be delivered
to the output tray, and this may help in reducing the problem of the trailing edge remaining.
However, the Z-fold support tray cannot be attached if Extension Vacuum Feed Banner Sheet Tray Type
S14 is attached to Finisher Shift Tray 1.
Also, note the following when attaching the Z-fold support tray.
• The accuracy of printed paper alignment is not guaranteed.
• The maximum stackable number of envelopes is 30. (Remove the stacked envelopes from the
output tray when their number reaches 30.)
298
[A]
M0EDIC1385
[A]
M0EDIC1385