Ricoh Pro C7500 Original Instructions Manual page 230

8. Troubles Related to Paper Feeding and Delivery (Main)
2. In [Detailed settings] for custom paper, select 1341: [Motor Speed] and then increase the
value for the applicable setting by 0.1%.
If this problem occurs with single-sided printing
If this problem occurs with duplex printing
If this problem occurs only with turned-over
paper delivery
3. Print the image. Has the problem been resolved?
Yes
No
Solution: Adjusting the Decurler Setting
(a) Scratches or Streaks on the Front of the Paper / Paper Creases or Bent Corners
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, check the decurling level in 1321-01: [Correction
Mode].
3. In accordance with the decurling level, decrease the applicable setting's value by 0.5%.
If set to "Correction Off"
If set to "Correction
Weak"
If set to "Correction
Strong"
4. Print the image. Has the problem been resolved?
Yes
228
Finished!
Start over from Step 2.
If the problem persists even after decreasing the values by up to 1.0% in total, there
is a possibility of another cause, so restore the previous settings and see other
troubleshooting.
1321-02: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Off
1321-03: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Weak
1321-04: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Strong
Finished!
1341-09: Motor Speed: Speed Adjustment:
Paper Output Roller
1341-10: Motor Speed: Speed Adjustment:
Switchback: Entrance Roller
1341-11: Motor Speed: Speed Adjustment:
Switchback: Exit Roller