6.
In [Detailed settings] for the custom paper you are using, select 1231: [Print Speed], and
then set the value in the following corresponding settings to [Middle].
• 1231-01: Print Speed: BW/FC/FCS: BW/FC/FCS
• 1231-02: Print Speed: FCS: Clear/Special
• 1231-03: Print Speed: FCS: White
• 1231-04: Print Speed: FCS: Metallic
• 1231-06: Print Speed: S: Clear/Special
• 1231-07: Print Speed: S: White
• 1231-08: Print Speed: S: Metallic
• 1231-10: Print Speed: BW/FC/FCS: Fuser Setting HQ: BW/FC/FCS
• 1231-11: Print Speed: FCS: Fuser Setting HQ: Clear/Special
• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
7.
Print the image. Has the problem been resolved?
Print 20 sheets of the image, then another 10.
Yes
Finished!
No
Go to the next step.
8.
Print speed is [Middle], lower it to [Low].
9.
Print the image. Has the problem been resolved?
Print 20 sheets of the image, then another 10.
Yes
Finished!
No
Go to the next step.
• If a paper jam occurs in the fusing unit due to a decrease in the print speed, reset the print
speed to the default value, and then go to the next step.
10.
In [Detailed settings] for custom paper, increase the value in 1238: [Fusing Cleaning] by
one step.
• 1238-01: Fusing Cleaning: BW/FC/FCS: Cleaning Interval: BW/FC/FCS
Spots
185