5. Image Quality Problem: Lines/Streaks
• 1231-12: Print Speed: FCS: Fuser Setting HQ: White
• 1231-13: Print Speed: FCS: Fuser Setting HQ: Metallic
• 1231-15: Print Speed: S: Fuser Setting HQ: Clear/Special
• 1231-16: Print Speed: S: Fuser Setting HQ: White
• 1231-17: Print Speed: S: Fuser Setting HQ: Metallic
• You can reduce the vibration of the intermediate transfer roller by decreasing the print speed,
but doing so also reduces throughput.
• If set to "Middle", throughput is reduced to 85% of that when set to "High".
5.
Print the image. Has the problem been resolved?
Yes
No
6.
Set the value in the following corresponding settings to [Low].
• If set to "Low", throughput is reduced to 50% of that when set to "Middle".
7.
Print the image. Has the problem been resolved?
Yes
No
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
148
Finished!
Go to the next step.
Finished!
No further improvement is likely.