Ricoh Pro C7500 Original Instructions Manual page 44

4. Image Quality Problem: Full Page
No
7. Adjust the value for the intermediate (image) transfer output until the side effect is no
longer noticeable.
8. Select 1341: [Motor Speed], and then increase the value of 01: [Transfer Timing Roller]
by 0.1%.
• If toner blasting occurs within 90 mm (3.5 inches) of the leading edge of the paper, skip this
step and go to Step 10.
9. Print the image. Has the problem been resolved?
Yes
No
10. Does any of the following problems occur?
• Hazing
• Banding
Yes
No
11. Decrease the value of [Transfer Timing Roller] in 1341: [Motor Speed] until the problem is
sufficiently reduced.
12. Select 1201: [Max Image Density], and then decrease the value in 01: [Black].
13. Print the image. Has the problem been resolved?
Yes
No
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select
"Metallic" when using Gold or Silver.
If toner blasting occurs to the lines at the leading edge of the paper.
You can reduce it by increasing the margin at the leading edge of the paper.
Custom Paper Settings
42
Finished!
Go to the next step.
Start over from Step 8.
Go to the next step.
Finished!
Finished!
Start over from Step 11.
If the problem persists even after decreasing the value to the lower limit, there is no
other solution. Apply the best setting among those with which you have printed.