Cause:
Occurs when the speed of the intermediate transfer belt and the speed of the paper feed are different.
Solution:
1.
If the paper is not registered as custom paper, register the brand of the paper.
2.
In [Detailed settings] for custom paper, select 1341: [Motor Speed] and check the value in
02: [Paper Transfer Belt].
If it is "0.5%" or below, go to the next step.
If not, there is no other solution.
3.
Decrease the value in [Paper Transfer Belt] by 0.1%.
• Errors may occur depending on the degree of adjustment and conditions. In such a case,
contact your service representative.
• Decreasing the paper transfer roller speed may cause the image to expand or contract in the
subscanning direction. Such a problem may be resolved by increasing the value for [Image
Magnification] in [Manual Adjustment] in [Adjust image position] on the [Media] hub.
4.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Start over from Step 2.
Uneven Glossiness Occurring Partly
Uneven glossiness occurs partly.
278 mm
(10.9 in.)
278 mm
(10.9 in.)
DXT868
Uneven Density
83