Trailing Edge Of Stapled Sheets Close To The Paper Exit - Ricoh Pro C7500 Original Instructions Manual

Trailing Edge of Stapled Sheets Close to the Paper Exit

Cause:
If the stapled sheets are curled strongly or become limp after delivery, the trailing edge of the sheets
may be too close to the paper exit when the paper is stacked.
Trailing edge
too near exit
Output tray
Paper feed direction
If this happens, stapled sheets, when delivered, may push the previously delivered sheet, resulting in
paper bending or misfeeding.
Occurrence conditions:
• There is a tight curl on a delivered set of stapled sheets.
• Limp paper such as thin or recycled paper is used.
Solution:
1. Attach the Z-fold support tray for multi-folding unit.
2. Print the image. Is the problem resolved?
Yes Finished!
No Go to the next step.
3. In [Detailed settings] for custom paper, select 1321: [Correct Paper Curl], and then
specify [U Curl Correction Level: Large] or [U Curl Correction Level: Small].
4. Print the image. Is the problem resolved?
Yes Finished!
No Contact your service representative.
Paper exit
CEZ593
Finisher/Booklet Finisher
299