Mga Millennium Graphics Controller; If You Are Using Windows Nt 4.0; Monitor Tab; Configuration Tab - Compaq Deskpro 2000 Series Reference Manual

MGA Millennium Graphics Controller

If you are using Windows NT 4.0

Monitor Tab

Configuration Tab

-10
3 Using Compaq Utilities
If this computer setup does not include the Matrox driver for
Windows NT 4.0, the MGA Panel will not be available and the
monitor type will automatically be set.
Use the MGA Panel to select a monitor type, configure 3D
accelerations, and obtain information about the MGA
Millennium graphics controller installed in your computer.
To access the MGA Panel, double-click the MGA Panel icon,
located in the Microsoft Windows NT Control Panel.
Use Monitor to select a monitor. Complete the following steps:
1. Click the Monitor tab in the MGA Panel.
2. If you have multiple graphics controllers or monitors
installed, choose the Millennium board ID first, at the
upper-right corner of the page.
3. Select the monitor controlled by the Millennium graphics
controller.
4. Perform this procedure for each graphics controller that
you have installed.
5. Click Save and restart your computer when prompted to do
so.
Use Configuration to select 3D acceleration and language
preferences. Complete the following steps:
1. Click the Configuration tab in the MGA Panel.
2. Enable 3D acceleration preferences (Z Buffer, Double
Buffer, or Sub Pixel Precision) by clicking to place an
arrow in the appropriate box or boxes.
3. Disable 3D acceleration preferences by clicking to remove
the arrow from the appropriate box or boxes.
4. Select your language preference for the MGA Panel text by
choosing the appropriate language in the language box.