Compaq Deskpro 2000 Series Reference Manual page 154

Japanese Notice
Battery Replacement Notice
Power Cord Set
Requirements
Only authorized technicians trained by Compaq should attempt
to repair this equipment. All troubleshooting and repair
procedures are detailed to allow only subassembly/module level
repair. Because of the complexity of the individual boards and
subassemblies, no one should attempt to make repairs at the
component level or to make modifications to any printed wiring
board. Improper repairs can create a safety hazard.
WARNING:
Your computer is provided with a battery-powered
!
real-time clock circuit. There is a danger of explosion and risk of
personal injury if the battery is incorrectly replaced or mistreated.
Do not attempt to recharge the battery, disassemble it, immerse it
in water, or dispose of it in fire. Refer to Appendix H for
replacement procedures.
For more information about real-time clock battery replacement or
proper disposal, contact your Compaq authorized reseller or service
provider.
The voltage select switch feature on the computer permits it to
operate from any line voltage between 120 or 240 volts AC.
The power cord set (flexible cord or wall plug) received with
the computer meets the requirements for use in the country
where you purchased the equipment.
Power cord sets must meet the requirements of the country
where you use the computer. For more information on power
cord set requirements, contact your Compaq authorized reseller
or service provider.
-5
Reference Guide A