Compaq Deskpro 2000 Series Reference Manual page 52

4. Select the option to view the device list.
A list of the installed hardware devices appears.
5. Verify that TEST correctly detected the devices installed.
This utility will detect all devices manufactured by
Compaq; devices from other manufacturers may not be
detected.
If the list is correct, select OK and go on to step 6.
If the list is incorrect, be sure that any new devices are
installed properly. If you do not find an installation
problem, call your Compaq authorized dealer, reseller,
or service provider.
6. Select one of the following from the test option menu:
Quick Check Diagnostics—This option runs a quick,
general test on each device with a minimal number of
prompts. If errors occur, they are displayed when the
testing is complete.
Automatic Diagnostics—This option runs unattended,
maximum testing of each device with minimal
prompts. You can choose how many times to run the
tests, to stop on errors, or to print or file a log of
errors.
Prompted Diagnostics—This option allows
maximum control over the device testing process. You
can choose attended or unattended testing, decide to
stop on errors, or choose to print or file a log of errors.
7. Follow the instructions on the screen as the diagnostic tests
are run on the devices. When the testing is complete, the
test option menu appears again.
When running TEST, record any error message numbers
and have them available when you contact your Compaq
authorized dealer, reseller, or service provider for
assistance.
8. Exit to the Compaq Utilities menu.
-7
Reference Guide 3