Installing A Hard Drive Into A 3.5-Inch Drive Bay - Compaq Evo D510 MT Hardware Reference Manual

Hardware Upgrades

Installing a Hard Drive into a 3.5-inch Drive Bay

✎
2–20
9. Connect the drive power 1 and signal 2 cables.
Connecting the Drive Cables
10. Remove the appropriate bezel blank from the subpanel inside the
front bezel. See the section "Removing Bezel Blanks" for more
information
11. Replace the computer access panel.
12. Reconfigure the computer, if necessary. See the section
"Installation Sequence" for more information.
Compaq does not support mixing IDE and SCSI hard drives in the
same system. If you are replacing a hard drive in bay 4 or bay 5, it
should be of the same type.
To install a hard drive in a 3.5-inch drive bay:
1. If you have locked the Smart Cover Lock, use Computer Setup to
unlock the lock.
2. Shut down the operating system properly, then turn off the
computer and any external drives, disconnect the power cord
from the power outlet, and remove the computer access panel.
3. Remove the front bezel.
Hardware Reference Guide