Compaq Deskpro 2000 Series Reference Manual page 164

appendix
E
RROR
This appendix lists the error codes that you may encounter
during the Power-On Self-Test (POST) or after restarting the
computer, the probable source of the problem, and what steps
you can take to resolve the error condition.
POST Error Messages and Codes
Error Code
101-ROM Error
101-I/O ROM Error
102-System Board
Failure
162-System Options
Error
162-System Options
Not Set
163-Time & Date Not
Set
164-Memory Size Error
170-Expansion Device
Not Responding
172-ISA Configuration
Nonvolatile Memory
173-PCI Slot ID
Mismatch
C
M
ESSAGES
Probable Source
of Problem
System ROM
checksum.
Options ROM
checksum.
DMA, timers, etc.
No diskette drive or
mismatch in drive type.
Configuration incorrect.
Invalid time or date in
configuration memory.
Configuration
memory incorrect.
Board not ready after
power-on delay.
Nonvolatile
configuration
memory corrupt.
PCI Board replaced.
Configuration not
updated.
Action
Contact your Compaq
authorized service provider.
Contact your Compaq
authorized service provider.
Replace the processor board.
Run Computer Setup or
Windows 95 utilities.
Run Computer Setup or
Windows 95 utilities.
Run Computer Setup or
Windows 95 utilities.
Run Computer Setup or
Windows 95 utilities.
Run Computer Setup or
Windows 95 utilities.
Run Computer Setup or
Windows 95 utilities.
Run Computer Setup or
Windows 95 utilities.
Run Computer Setup or
Windows 95 utilities.
Continued
Reference Guide
-1
C