Installing A Hard Drive Into A 3.5-Inch Drive Bay - Compaq 470022-515 - Evo - D300 Hardware Reference Manual

Hardware Upgrades

Installing a Hard Drive into a 3.5-inch Drive Bay

2-16
Connecting Cables
Remove the appropriate bezel blank from the front bezel. See the
section "Removing Bezel Blanks" for more information.
7. Replace the front bezel.
8. Replace the computer cover.
9. Reconfigure the computer, if necessary.
Compaq does not support mixing IDE and SCSI hard drives in the
same system. If you are replacing a hard drive in bay 4 or bay 5, it
should be of the same type.
To install a hard drive in a 3.5-inch drive bay:
1. Shut down the operating system properly, then power off the
computer and any external drives, disconnect the power cord
from the power outlet, and remove the computer cover.
2. Remove the front bezel. See, "Removing the Front Bezel."
Hardware Reference Guide