When To Reconfigure The Computer In Windows 95 - Compaq Deskpro 2000 Series Reference Manual

When to
Reconfigure
the Computer in
Windows 95
-2
6 Upgrading the Minitower Computer
1. Open the computer by removing its outside cover. Refer to
the section "Removing the Computer Cover" in this
chapter for instructions.
2. Install any optional equipment (ISA or PCI expansion
board, processor upgrade, memory, drive). Refer to the
applicable sections of the documentation that comes with
the optional equipment for the instructions.
3. Replace the computer cover.
4. Reconnect the keyboard and monitor.
5. Turn on the monitor, computer, and any devices you want
to test.
6. If you are using Windows 3.1, run the Computer Setup
utility to reconfigure the computer. Refer to Chapter 3,
"Using Compaq Utilities," for instructions.
7. Test the computer (optional) using the TEST utility.
Windows 95 automatically recognizes all Plug and Play
devices installed. However, if the device is not a Plug and Play
device or is not installed properly, follow the instructions
below:
1. Go to the Control Panel.
2. Select the Add New Hardware icon.
3. Follow the instructions on the screen.
If you add a board or other option, run the Computer Setup
utility after you complete the installation. If configuration
settings are incorrect, one or more devices may not work
properly, and you may receive an error message. If this occurs,
run the Computer Setup utility again. Refer to Chapter 3, "Using
Compaq Utilities," for more information.