Installation Instructions - Compaq Deskpro 2000 Series Reference Manual

Installation
Instructions
Removing the Front Bezel
Compaq strongly recommends that only an authorized service
provider replace your primary hard drive.
Follow these steps to install an additional hard drive into one
of the drive bays:
Installing a third-party hard drive requires the installation of
special Compaq flanged screws that are stored in the front of the
computer frame.
1. Turn off the computer and remove the computer cover as
described in the section "Removing the Computer Cover."
2. Remove the front bezel from the computer by locating the
tabs 1 on both sides of the bottom of the bezel. Push the
tabs in and rotate the bezel up
out.
2 from the bottom and pull
Reference Guide
-23
5