Completing the Installation
1. Connect the hard drive signal and power cables.
Connecting the Signal and Power Cables
2. Change the jumper settings if indicated in the
documentation supplied with the new hard drive.
If you change the drive configuration or if you add an additional
hard drive, you may need to change the jumper settings. For
more information on changing the jumper settings, see the
documentation supplied with the new hard drive. By setting the
jumpers on the drives, you are determining which drive is the
primary drive and which is the secondary drive.
If your new drive includes the cable select feature, no jumper
setting changes are required. Refer to the documentation
supplied with the cable for instructions on using the cable select
feature. If you install a third party hard drive, you will need a
jumper cable. For a nominal fee, a jumper cable (part number
112528-2) can be purchased from Compaq Computer
Corporation.
-25
Reference Guide
6