Installing The Cable Cover; Turning On The Power - Eizo CuratOR EX3242-3D Instructions For Use Manual

2-5. Installing the Cable Cover

1.
Align the cable cover on the back of the monitor in such a way that the cables
can go through the cable outlet port.
2.
Insert the cable cover tabs into the grooves in the monitor.
3.
Tighten the screws at the left and right-hand holes on the bottom side of the
monitor.
Cable outlet port
Attention
• Ensure that cables are not pinched between the cable cover and the monitor.
• Securely tighten the screws in the two locations. (Tightening torque: 0.4 Nm to 0.7 Nm, Tool used: Phillips-head
screwdriver (No. 2))
• Avoid subjecting the terminal and cable to stress.
• Do not pack or transport with the cable cover attached.

2-6. Turning On the Power

1.
Turn on the power switch on the bottom of the monitor, and then turn on the
monitor.
The power indicator on the front of the monitor lights up green.
If the indicator does not light up, see ""Chapter 3 If No Image Is Displayed" (page 21).
Note
• If the power switch on the bottom of the monitor is turned off, the monitor is turned off.
20
Chapter 2Chapter Installation / Connection
Cable cover
Cable cover reverse view
Screw holes
Tabs
Tabs