Installing The Cable Cover; Turning On The Power - Eizo CuratOR EX5542 Instructions For Use Manual

2-4. Installing the Cable Cover

1.
Align the cable cover on the back of the monitor in such a way that the cables
can go through the cable outlet port.
2.
Insert the cable cover tabs into the grooves in the monitor.
3.
Tighten the screws at the left and right-hand holes on the back side of the
monitor.
Attention
• Ensure that cables are not pinched between the cable cover and the monitor.
• Securely tighten the screws in the two locations. (Screw tightening torque: 0.4 Nm to 0.7 Nm)
• Avoid subjecting the terminal and cable to stress.
• Do not pack or transport with the cable cover attached.

2-5. Turning On the Power

1.
Turn on the power switch on the back side of the monitor, and then turn on the
monitor.
The power indicator on the front of the monitor lights up green.
If the indicator does not light up, see
Note
• If the power switch on the back side of the monitor is turned off, the monitor is turned off.
18
Chapter 2 Installation / Connection
"Chapter 3 If No Image Is Displayed" (page 19).