Engine Feet (Information) - Kohler KDI 1903M Workshop Manual

5. Position bulkhead D onto shroud F.
6. Fasten brace G by means of capscrews E
(tightening torque at 25 Nm).
7. Fasten guard D by means of capscrews C
(tightening torque 10 Nm).
8. Fit the sleeve B on the fitting of the radiator M and
of the thermostat cover Y.
9. Tighten the clamps A.

11.15 Engine feet (information)

NOTE: Component not necessarily supplied by KOHLER. The
representation of the engine is purely indicative.
Important
•
The motor supports A can be installed on the bell B or
on the crankcase C by using the screws D (tightening
torque at 50 Nm).
INFORMATION ABOUT OPTIONAL
COMPONENTS
Fig. 11.68
Fig. 11.69
Fig. 11.70
Fig. 11.71
11
169
EN