Kohler KDI 1903M Workshop Manual page 171

INFORMATION ABOUT OPTIONAL
4. Apply capscrews E into the fastening holes and use
torque at 10 Nm.
5. Loosen capscrews E, leaving approximately 1 mm
leeway (position A) between the neck surface of
capscrews E and oil sump F.
6. Place flange housing or plate L onto crankcase H,
complying with centring tap pins M.
7. Using 2 capscrews A, fasten housing or plate L onto
crankcase H (tightening torque at 20 Nm).
8. Using 2 capscrews A, fasten housing or plate L onto
oil sump F (tightening torque at 20 Nm).
Fig. 11.77
9. Fasten oil sump F by tightening capscrews E and
strictly following the order shown in Fig. 11.77
(tightening torque at 20 Nm).
10. Loosen capscrews A and remove housing or plate L
(Fig. 11.76).
11. Fasten oil sump F by tightening capscrews E and
strictly following the order shown in Fig. 11.77
(tightening torque at 47 Nm).
Loosen the screw 1 again and tighten it to 47 Nm.
COMPONENTS
Fig. 11.76
Fig. 11.78
11
171
EN