Kohler KDI 1903M Workshop Manual page 51

Before starting, remove any tools that were used to service the engine and/or machine. Make sure that
•
all guards have been refitted.
Do not mix fuel with elements such as oil or kerosene. Failure to comply with this prohibition will cause
•
the non-operation of the catalyst and non-observance of the emissions declared by KOHLER.
Pay attention to the temperature of the oil filter when the filter itself is replaced.
•
Only check, top up and change the coolant fluid when the engine is off and reached the ambient
•
temperature. Coolant fluid is polluting, it must therefore be disposed of in the correct way.
Do not use jets of air and water at high pressure on the cables, connectors and injectors.
•
Important
Only use the eyebolts A installed by KOHLER to move the engine (Fig. 3.1).
•
The angle between each lifting chain and the eyebolts shall not exceed 15° inwards.
•
The correct tightening of the lifting brace capscrews is 25 Nm.
•
Do not interpose spacers or washers between the eyebolts and engine head.
•
Fig 3.1
SAFETY INFORMATION
3
51
EN